Muse gadgets / ideaspark ESP32 with 1.9" LCD
Status screenOfficially supportedESP32 SDK
ideaspark ESP32 with 1.9" LCD
Board $12-18 · about $22 with cable/parts
Beginner · no toolsA USB-C data cable and one flash command over its CH340 bridge.
Classic ESP32 (no PSRAM) with a 1.9" 170x320 ST7789 LCD. Muse shows status and draws images straight to the screen, but there is no home-network tunnel. Needs chip rev 3.0+ for signed apps (the D0WD-V3 qualifies). Cheap, bare PCB, no case.
What it can do
- Voiceno
- Images · Coloryes
- Touchscreenno
- Camerano
- Air sensorsno
- Home-network tunnelno
- Batteryno
- Over-the-air updatesno
Things to say to it
“Show a picture of a sunset on my gadget.”“Put today's top three tasks on the gadget's screen.”
What you need
See inside
Take the ideaspark ESP32 with 1.9" LCD apart
Drag to turn it, pull the slider to explode it, and tap a part to learn what it does. Open the full 3D view
Loading 3D model
Developer details · build command and SDK notes
Your coding agent runs this for you. The full sequence (token, flash, pair) is on the build page.
tools/board.sh ideaspark buildLimits
Good to know
- Boards without PSRAM (classic ESP32, ESP32-C6) run without the home-network tunnel; Muse can still reach and control them.
- Pairing has no manufacturer verification and can't prevent an active man-in-the-middle attack.
- Builds are signed with the included development key and never enable Secure Boot. Enable NVS encryption (CONFIG_HOMEHUB_NVS_ENCRYPTION).
- Custom ESP32 commands are not a documented API yet: the command set (display.draw_url, sensors.read, camera.capture, ...) is hardcoded in main/app.c.
Alternatives
Compare with
Primary links